10
In the s
toP
mode, a new
switch can be connected
without influence on status
or recording.
Press H-Key
New start of
measurement
Back to the M
ano
-Mode:
Activate e
nd
-->
Activate M
Ano
Note:
The test measurements can be started in each
position of the connected pressure switch.
The first point is automatically written into the
small right display (Low) if the measurement
started at high pressure and the pressure switch
was switching at a lower pressure.
An increase of pressure from this status writes
the new switch point automatically into the
small left display (High). The pressure decrea-
sing again results in writing the new switch point
into the Low again.
This allows various switch points to be regis-
tered from the same pressure switch. They are
being recorded in the memory in pairs.
Activating r
un
can start a new measurement at
any point of the function.
P
st
-m
ode
(F
ull
-V
ersion
only
)