Easy Fountain Instructions
4724L - Vintage Bird Bath Fountain
www.kelkay.com
STAGE 1
STAGE 2
STAGE 3
STAGE 4
STAGE 5
STAGE 6
Connect the tubing to the outlet of the pump. Place the pump in the water reservoir in
the opening in the centre of the fountain.
Please read the assembly and pump operating instructions carefully and observe the safety instructions.
Position the fountain in your desired location.
Thread the long transformer wire down through the pedestal and push the cable with 2 pins into the
transformer plug and screw over the plastic collar.
Connect the top bowl to the pedestal and twist to lock into place. Position the plate in the bath ensuring
the pump tubing is fed through to the top of the pedestal.
Carefully fill the fountain with sufficient water to fully submerge the pump.
ELECTRICAL SAFETY:
If outdoors the outlet must be waterproof. We
recommend the use of a residual current device (GFI) Ground Fault
Interrupter (available from all good D.I.Y. stores) when connecting the
fountain to the electric supply.
PUMP FLOW:
The pump flow can
be adjusted with the regulator, this
is found on the inlet of the pump.
We recommend starting with the
flow regulator fully open and then
adjusting down if required.
Connect the plug to your mains outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.