Easy Fountain Instructions
45013L - Flame Fountain
STAGE 1
STAGE 2
STAGE 3
STAGE 4
STAGE 5
Carefully fill the water with water taking care to ensure the pump is fully submerged. Never allow
the pump to run dry.
Connect the tubing to the outlet of the pump. Place the pump in the water reservoir through the
opening in the back of the fountain.
Connect the two ends of the L.E.D lighting wire together and screw over the plastic collar.
HELPFUL TIP - With a pump that is this small, do not turn on the power until it is fully submerged.
ELECTRICAL SAFETY:
If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.
PUMP FLOW:
The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
Push the cable with 2 pins that extends from the pump into the transformer.
Connect the plug from your transformer to a mains power outlet.
www.kelkay.com