ASSEMBLY BASIS
USING THE HEATER
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label of the unit.
2. When plugged in, turn on the Main power switch
at the back of the unit.
3. When in Standby mode, only press on the control panel will respond to your touch, and
the LED display shows the room temperature. Press to access the rest of the
control panel.
(a) Low Power: 1300W (Press to switch it, one light on )
(b) High Power: 2000W (Press to switch it, two light on together )
(c) TIMER: Press this button repeatedly to set a period after which the heater will turn
itself off (From 0 hour -8 hours)
(d) + , - : adjust room temperature .Temperature setting from 10-49
℃
. Press “ ” to
increase the desired temperature and “ “ to decrease the desired temperature. When
the room temperature lower 4
℃
than the settled temperature of unit, it’s high power
working, lower 2
℃
, lower power working, if room temperature reach the setting
temperature, the heating stop, fan is permanently on till room temperature lower than the
setting temperature 2
℃
, the unit automatically return to lower power heating, if room
temperature lower 4
℃
, higher power heating, it's automatically return to heating.
(e) Swing : Press
to activate swing. Press it again to cancel.
(f) Press to turn off the heater, the unit will keep working 30 seconds of cool air after turn
off it . this design can protect item use longer.
Fixing the base
with screws
Registration hole
Pillar
Step1
Step2
Fixing the base with screws
