S540 Power Semiconductor Test System Administrative Guide
Section 3: Equipment startup
S540-924-01 Rev. D / January 2019
3-5
Start the ACS software
To start the ACS software, log on to the computer and double-click the ACS icon.
For more information about the ACS software setup procedures, refer to the
Automated
Characterization Suite (ACS) Reference Manual
(part number ACS-901-01).
Shut down using ACS
To shut down using the Automated Characterization Suite (ACS) software:
You must have administrator rights in the ACS software to shut down the S540 system.
1.
Double-click the
Shutdown
icon on the computer desktop.
2.
In the dialog box that opens, click
Yes
that you want to shut down the S540 tester.
The message in the following figure opens after you click
Yes
to shut down the S540. You must wait
until the 4200A-SCS and the system computer shut down before you press the power button on the
system cabinet. It may take several minutes for the system to shut down.
Figure 38: Shut down the S540
3.
Once the ACS host computer has shut down, press the power button on the front door of the
system cabinet.