Document number: S46-901-01 Rev. F / March 2011
2-3
S46/S46T/S46L Microwave Switch System Instruction Manual
Section 2: Connections
Figure 2-2
Rear panel (all models)
Simplified schematic
shows a simplified schematic diagram of the S46/S46T/S46L. Configuration is as
follows:
•
RELAY 1 through RELAY 8 (for S46L, RELAY 1 through RELAY 4) are 2-pole relays, each
with two inputs (normally closed and normally open) and one common.
•
RELAY A through RELAY D on the S46 and S46T can be 4-pole, 6-pole, or MSPDT relays,
each with a maximum of six inputs and one common. The number of inputs depends on
relay configuration, as shown by the dotted lines in the diagram. The S46T can also
accommodate up to four transfer switches. The S46L only supports SP6T relays.
1 4
2 816
Primary Address
DIP Switch
IEEE-488
Connector
!
!
42V MAX.
ANY CONDUCTOR
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE FUSE WITH SAME TYPE AND RATING.
Line Fuse
Power Line
Receptacle
LINE FUSE
SLOWBLOW
1.6A, 250V
LINE RATING
100-240VAC
50, 60Hz
80VA MAX
