KPXI-CON-900-01 Rev. A / January 2007
Return to
1-3
KPXI System Controller User’s Manual
Section 1: Introduction
Safety symbols and terms
The following symbols and terms may be found on the Model KPXI-CON System Controller or
used in this manual.
The
symbol indicates that the user should refer to the operating instructions located in the
manual.
The
symbol
shows that high voltage may be present on the terminal(s). Use standard safety
precautions to avoid personal contact with these voltages.
The
symbol on an instrument shows that the surface may be hot. Avoid personal contact to
prevent burns.
The
WARNING
heading used in this manual explains dangers that might result in personal injury
or death. Always read the associated information very carefully before performing the indicated
procedure.
The
CAUTION
heading used in this manual explains hazards that could damage the unit. Such
damage may invalidate the warranty.
Features
Model KPXI-CON controller features
• Standard 3U PXI form factor
• PICMG 2.0 CompactPCI Specification R3.0 compliant
• PICMG 2.8 PXI Specification Rev. 2.2 compliant
• Designed for Pentium® M processor, FSB 400MHz, CPU frequency up to 1.8GHz
• Two 200-pin DDR SO-DIMM sockets supporting up to 2GB RAM
• One 44-pin EIDE (primary IDE) with built-in 2.5” low profile HDD (40 GB, standard)
• Two CompactFlash interfaces for HDD and FDD replacement; CF Type II supports hot-
swappable CF card functionality
• Two USB 2.0 ports, two serial ports (RS-232) and one parallel port provided on the front
panel
• One AC ‘97 stereo audio output
• One TRIG I/O on the front panel for advanced PXI trigger function
• VGA output on the front panel supporting up to 2048 x 1536 resolution at 75Hz
• Intel
®
82545EM controller providing one 10/100/1000 Mb Ethernet port
• Supports 7 bus-master PCI devices on PXI/CompactPCI bus
• Programmable watchdog timer
!
Summary of Contents for KPXI
Page 96: ......
