Model 4299-3 Universal Single Rack Mount Kit Installation Instructions
PA-942 Rev. C / February 2008
3
Step 2: Install mounting hardware on instrument
NOTE
The instrument may be installed on the rack’s right side with the half-rack
front panel on the left side (as shown in the following illustrations), or on the
rack’s left side with the half-rack front panel on the right side (not shown).
1. Determine and select the unit’s side that is to be installed closest to the rack rail (see note above).
2. Secure front rack ear (2602-355) using two pan-head screws (see Figure 2).
Figure 2
Attach rack ear and front panel to instrument
RANGE
AMPS
350V
PEAK
AU
TO
SHIFT
LOCAL
PO
WER
RANGE
HOLD
CONFIG
HAL
T
Integra Series
Pan Head Screw (Phillips)
8-32x3/8PPH
(2 Places)
Pan Head Screw (Phillips)
8-32x3/8PPH
(2 Places)
Front Rack Ear
(2602-333)
(See Note**)
Half Rack
Front Panel
(2602-344)
(See Note**)
FRONT
Front
mounting
holes
Rear
mounting
holes
**When installing a 2100-DMM or Agilent unit, use
M4x12 screws in the front mounting holes; otherwise
use 8-32x3/8 screws in rear mounting holes.
3. Secure the half-rack front panel (2602-363) to the other side of the instrument using the two remaining
pan-head screws.
Half-rack
front panel
(5602-363)
(See note**)
Front rack ear
(2602-355)
(See note**)
** When installing a Model 2100 DMM or Agilent unit,
use M4x12 screws in the front mounting holes;
otherwise use #8-32x3/8 screws in the rear mounting
holes.
Pan-head screw (Phillips)
#8-32x3/8PPH
(2 places)
Pan-head screw (Phillips)
#8-32x3/8PPH
(2 places)