Model 4288-10 Rear Support Rack-Mount Kit Assembly and Mounting Instructions
4
PA-953 Rev. E / July 2018
Install the Model 3706A in the rack
You will need two people to install the Model 3706A in the rack.
To install the Model 3706A in the rack:
1. Place the Model 3706A in the rack. You will need to insert it at an angle and flex the support brackets to fit
them into proper placement in the rack.
2. Loosely attach the front panel to the front rack rails using four of the #10-32 screws.
3. Loosely attach the rear support brackets to the rear rack rails using the remaining four #10-32 screws.
4. Tighten the #10-32 screws to secure the instrument to the rack.
5. Tighten the #8-32 screws that secure the rear support brackets to the Model 3706A.
Install the support bracket
To install the support bracket:
1. Mount the support bracket to the rear support brackets using the #8-32 screws and washers. Note that
actual location of the bracket will depend on the placement of the support brackets. The following figure
shows a typical location.
Figure 3: Install the card support bracket
2. Install cards in the Model 3706A.
3. On the rack, replace the side panels and other items that might have been removed to prepare for
Model 3706A installation.
1
Model 3706A
2
Support bracket (part number 3706-355)
3
#8-32 screws
4
#8 x 3/4 washer
