Keithley 2701, Instruction Manual

Page: 31 / 61

Model 2701 Instrument Networking Instruction Manual Configuring TCP/IP addresses 3-11
Configuration in Windows 98/ME
Refer to Figure 3-4 .
1. Click on the Windows Start button.
2. Select Settings, then Control Panel.
3. Open the folder named Network.
4. Look for a TCP/IP entry. If you are configuring a computer with two network cards,
there should be two entries, one for each card. You will be able to tell the difference by
the listing; after the TCP/IP notation, there will be a reference to the NIC card(s). If
there is no TCP/IP protocol listed, you must add one. This is done by clicking the Add
button. Then click on Protocol, select Microsoft, and click TCP/IP.
5. After selecting the TCP/IP protocol, click the Properties button. On the IP Address tab,
select the method of obtaining your IP address. For an isolated network, click on
“Specify An IP Address”.
6. Complete the IP Address and Subnet Mask according to your network configuration.
7. The Default Gateway and the DNS settings could be needed when connecting to a cor-
porate network. For an isolated network, these settings are not used.
8. Follow the instructions on the screen and reboot as necessary.
Figure 3-4
Windows 98/ME Ethernet card settings