Model 2520 User’s Manual
Sweep Operation
7-11
summarizes the basic remote command sequence for performing the custom
sweep described above.
Table 7-5
Custom sweep programming example
Command
Description
*RST
:FORM:ELEM VOLT1,CURR2,CURR3
:SOUR1:CURR:MODE LIST
:SOUR1:LIST:CURR 0.2, 0.1, 0.4, 0.3, 0.5
:SOUR1:LIST:DEL 7e-3, 4e-3, 2e-3, 8e-3, 1e-3
:SOUR1:LIST:WIDT 10e-6, 50e-6, 35e-6, 20e-6, 60e-6
:SOUR2:VOLT 5
:SOUR3:VOLT 5
:OUTP1 ON
:READ?
:OUTP1 OFF
Restore GPIB default conditions.
Laser diode voltage, detector current data.
Current list sweep mode.
Set current sweep points.
Set pulse delay sweep points.
Set pulse width sweep points.
Detector 1 bias = 5V.
Detector 2 bias = 5V.
Turn on source outputs.
Trigger sweep, request data.
Turn off source outputs.
Summary of Contents for 2520
