Keithley 2000-SCAN-20, Instruction Manual, Page: 22 / 81

Card Connections and Installation 2-5
Card connectors
Figure 2-2 shows the input and output connectors for the card. Card connector J1036 provides
the HI and LO input connections for all 20 channels, and J1035 provides the HI and LO outputs.
Terminal identification for connectors J1035 and J1036 is provided in
Figure 2-3 and Table 2-1
and Table 2-2 , respectively
The J1035 connects to a plug that has four separate test leads. These test leads connect to the
rear HI and LO INPUT and SENSE jacks on the multimeter. Refer to “Output connections to
multimeter” on page 2-16 for more information.
NOTE It is not necessary to connect the OUT B leads for 2-pole mode operation.
The J1036 connects to a DB44 mass-terminated connector.
Figure 2-2
Card connectors
J1035
J1036
HI
LO
Black
Red
To DMM
Input
Red
To DMM
Sense
HI
LO
Black
Output
Connector
Input
Connector