POWER RACK ASSEMBLY INSTRUCTIONS
10
3
A
CONNECT AIR LINES AND COMMUNICATION WIRE
Remove the Bolts and Washers at the Bottom Frame. Tilt a Power Module with Bottom Frame to position the Cable
Tray. Then, route the Air Lines / Communication Wires and install the Cable Tray.
RIGHT SIDE
LEFT SIDE
AIR LINES AND PUSH-IN FITTINGS
COMMUNICATION WIRES
Connect the Air Lines and Communication Wires.
Push-in Fittings Method of Assembly:
1. Check that the end tube
is cut square and is free
from burrs.
2. Push the tube through
the release ring button
and grab ring into the
fitting.
3.
Push the tube firmly
through the 'O' ring until
it bottoms on the tube
stop, then pull back.
4. To disconnect, push the
tube into the fitting, hold
down the release button
and withdraw the tube.
IMPORTANT
: Click sound
confirms proper connection.
B
LEFT SIDE
RIGHT SIDE
Cable Tray
Bottom Frame
Power Module
