Keiser 002035BP, Operation Manual

Page: 8 / 24

08
AIR350 BIAXIAL UPPER BACK
|
OPERATION MANUAL
INSTALLATION AND PLACEMENT
TRAINING SPACE
Figure 4. Training Space for the Air350 Biaxial Upper Back
The equipment footprint is 51 inches x 48 inches (1,296 mm x 1,219 mm). The minimum recommended free space around the
equipment is 24 inches (610 mm) for the front and sides.
Figure 3. How to Connect the Equipment to
the Keiser Air Supply
Note: Additional Free Space may be required to accommodate mobility device access.
No assembly required. Place the Air350 Biaxial Upper Back on a flat, level surface. Make sure the base of the frame
makes full contact with the floor. If gaps are present, relocate the equipment to an even surface.
CONNECT THE EQUIPMENT TO THE KEISER AIR
SYSTEM
WARNING: Never connect equipment to an air
source capable of exceeding 120 psi / 8.27 bar.
Over pressurizing Keiser pneumatic equipment may
cause tubing to burst, breakage of equipment,
abnormal operation, or serious injury. Use only clean,
dry, regulated compressed air at the rated pressure
range of 100–120 psi / 6.89–8.27 bar.
1. Plug the Compressor into the appropriate power
source to power the Compressor ON
(allow the
Compressor to build up to a minimum of 100 psi /
6.89 bar; Keiser Compressor and Keiser Air System
not included, sold separately)
.
2. Connect the 1/4-inch Quick Disconnect (QD)
from the equipment into the Keiser Air Supply
(see Figure 3)
.
FREE AREA FOOTPRINT
24 inches
(610 mm)
24 inches
(610 mm)
24 inches
(610 mm)
Keiser Air System
(floor or wall air outlet)
Direct-connect to
Keiser Small Air Compressor
Keiser
Large Air Compressor
Keiser
Small Air Compressor
1/4-inch QD
48 inches
(1,219 mm)
51 inches
(1,296 mm)