Tool Required
Hex Allen Key
keilhauer.com
To install legs on a single standalone configuration, place sofa upside down on a clean
surface. Line up single legs (x4) with pilot holes located at the four corners of the underside
of the sofa. Once properly lined up, fasten 1 1/4” L Hex screw and small washer (x2) for
each leg.
Hardware Included
For alternating pieces within a configuration, see illustration above for the location of the
pilot holes for the 1 1/4” Hex screw & large washer (x4) which will be fastened to the sofa
ganging.
DO NOT install these prior to completing Step 3a & 3b.
Lower the middle sofa component down onto the exposed sofa ganging. From underneath the
sofa, use the Hex Allen key to fasten the 1 1/4” Hex screw & large washer (x4) to the exposed sofa
ganging teeth. Ensure all four are tightened to prevent the sofa components from shifting
(See Figure 3a & 3b).
Meander Legs & Ganging Assembly Instructions
1
2
1 1/4“ Hex screw
Steel Ganging Leg
Meander Curve Corner Assembly Instructions
Meander Single Unit Instructions
3 b)
3 a)
Steel Non-Ganging/ Corner Leg
Washer
(Large)
Washer
(Small)
Place the sofa upside down on a clean surface. In order to connect sofa pieces together via
ganging, the leg’s orientation must be flipped and re-fastened with 1 1/4” Hex screw and small
washer (x2) thereby exposing the ganging holes.
Place the sofa upside down on a clean surface. Corner components require installation of a 5th
single leg fastened with 1 1/4” Hex screw and small washer (x2) (See illustration above).