Keil MCB251, User Manual

Page: 48 / 60

42 Chapter 4. Programming
Using dScope to Debug the BLINKY Program
To load the BLINKY in the MCB251 evaluation board using dScope, you need
to perform the following steps:
n
Load the MON251.DLL CPU driver.
n
Configure the CPU driver for the appropriate COM port and baud rate.
n
Configure the CPU driver for serial break.
n
Load the BLINKY program.
n
Step through the BLINKY program.
Each of these steps is described in detail below.
Start dScope by selecting the dScope Debugger… command from the Run menu.
This loads dScope and sets the current path to the path in which your project file
is saved.