T-506 User Manual Version 3.2 | 14
4.3
Installation and adjustment of the handle
Unpack and remove the T-506 handle and connect it to the main unit as shown below. First,
align the lower end of the handle with the upper lever connector of the main unit as shown
in Figure (a) (note the alignment of the lower opening of the handle and the connecting rod
in the lever base). Then, insert the handle firmly into the connector as shown in Figure (b).
Finally, rotate it 45 degrees clockwise to complete the assembly.
1)
Probe 2) Handle connector 3) Handle top 4) Handle shaft 5) Locking Knob
After the handle shaft and the main assembly are completed, adjust the height of the handle
bar according to the height and usage habits of the staff - turn the locking knob
counterclockwise, loosen the fastening connection of the handle bar and the handle tube,
and then adjust the handle The height of the rod is at a suitable position, and finally the
knob is rotated clockwise to fix the handle bar and the handle tube.
