Benchy Sparkling - Instruction Manual
Page
7
of
16
Last Updated 3/06/2022 6:03 PM
Shanks and Taps Installation
1.
Remove the two plastic plugs on the front of the Benchy Sparkling by pinching the raised
clips on the back of the plugs together.
2.
Insert the 100mm duotight long shanks into the pre-cut holes.
3.
Secure the shanks using a
5/8” Lock nut
and firmly tighten the duotight fitting onto the short
shank thread.
4.
Tighten your Flow Control NukaTaps onto the shank firmly with a 7 in 1 tool (
).
Note: The NukaTap FC needs to be very tight to form a seal.
5.
Redirect the SPARLING OUT and CHILLED OUT hosing and push firmly into the duotight
fittings on the 100mm duotight long shanks.
1
2
3
4
