www.Kegco.com
5
1-800-710-9939
Installation Instructions
BEFORE USE:
Remove the exterior and interior packaging.
Before connecting the unit to the power source, let it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
This
Beverage Cooler is designed for free standing installation only, and should not be recessed or built-in.
Allow 5 inches of space between the back and sides of the Beverage Cooler, which allows the proper air
circulation to cool the heat sink.
Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded. To level the
appliance, adjust the front leveling legs at the bottom of the unit.
This Beverage Cooler uses compressor refrigeration technology and is not designed for storage in hot areas like
garages, warehouses or outdoors since it is designed to operate at a maximum of 30 degrees below the ambient
temperature.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit to perform improperly. The optimal ambient temperature
range is 65°F - 80°F
Avoid locating the unit in damp areas.
Plug the beverage cooler into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or electrical grounding should be directed to a certified electrician or authorized products service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 to 4 hours before placing
bottles in the appliance.
Setting Temperature
To control the internal temperature, adjust the control dial
according to the ambient temperature or purpose of use.
The first time you turn the unit on, set the temperature
control to "7" (coldest setting).
The temperature range to control is 33°F - 54°F, and the
relative setting position is from "0" to "7". After 24 to 48
hours, adjust the temperature control to the setting that
best suits your needs. The setting of "4" should be correct
for home or office Beverage Cooler use.
If the unit is unplugged, has lost power, or turned off; you must wait 3 to 5 minutes before restarting the unit. If you
attempt to restart before this time delay, the Beverage Cooler will not start.
If you are going on vacation, you may leave the beverage cooler operating during vacations of less than three weeks. If
the appliance will not be used for several months, you should remove all items and turn off the appliance. Clean and dry
the interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if necessary.
Can Configuration
You can store around 91 12oz cans in this Beverage Cooler by placing 15 cans horizontal on the top shelf, 28 cans
upright on the middle two shelves and 20 more cans can be stored on the bottom of the cabinet below the shelf. To
achieve 20 cans in the bottom area, place 5 rows of 3 cans standing upright and another 5 cans horizontally on top of
them.
As bottles differ in size and dimensions, the actual number of bottles you may store varies.
