INSTALLATION
Speedster
page 5
Installation
Caution!
Installation of and maintenance on the Speedster should be done by a qualified technician. Parts of
the machine can reach a temperature of close to 140 °C (284 °F). The steam/hot water boiler contains
water and pressurised steam of 135 °C at 1.45 bar overpressure (275 °F at 21 PSI), temperature and
pressure in the coffee system reaches up to 96 °C at 12 bar overpressure (205 °F at 175 PSI).
Danger
We cannot be held responsible for damage and/or injuries resulting from actions performed on our
machines by non-qualified personnel.
Parts needed, included in shipment
Machine
2 high pressure hoses, each 1.5 m (5 ft)
1 high pressure hose, 0.5 m (20 inch)
Pump with motor, 29x14x19 cm (length x width x height; 12x6x8 inch)
Discharge hose with stainless steel clamp
Tools needed
Spanner 20-22, 30 (or adjustable) mm
Allen key 4 mm
Screw driver
Sharp knife and side cutter
Bucket
Extras needed (not in shipment)
suitable water treatment system
Connect water supply
Figure I 1. Water treatment system (not included) on left is connected to the pump on the right. Water
flow is according to arrows. Tap and Speedster will be to left of figure.
water treatment
system
pump with
motor
