1. Open the lid and remove any packaging contents.
2. Place the Towel & Blanket Warmer on a hard, dry and level surface.
3. Insert the plug into a standard 120 V outlet, please refer to the Specification on page 10
*NOTE:
This Towel & Blanket Warmer has a 3-prong grounding plug. To reduce the risk of
electric shock, plug the power cord into a grounded (earthed) electrical outlet.
The Towel & Blanket Warmer can comfortably warm up two large cotton bath towels or
a personal throw blanket.
1. Insert the power cord into an electrical outlet.
2. Open the lid and place ONLY DRY towel(s) or a blanket inside.
*NOTE:
Only pure cotton or other material of clothing with a temperature resistance of
140°C/284°F or more can be heated.
Placing damp or wet towels inside the product can damage it and pose serious safety risks.
3. Close the lid.
4. Press the ON/OFF BUTTON. The white LED background light will light up to indicate that
the product is heating.
The default heating time is 15 minutes. When the inner wall temperature reaches 50 ℃/122℉,
the LED light above the switch will be red. (After shutting down, as long as the internal
temperature is higher than 50 ℃/122℉, the LED light above the switch will flash red. Which
means it is unsafe to touch. Please wait for it to cool down.)
5. 1 minute rapid heating, 6 minutes to reach high temperature.
*Note:
The Towel & Blanket Warmer can reach approximately 266°F/130°C and remain hot
for the duration of the heating cycle.
6. Open the lid to remove the towel(s) or blanket.
*Note:
To avoid damage to the product, gently raise the lid when removing items.
7. Press the ON/OFF BUTTON at any time to stop or start the heating cycle.
8. The product will automatically turns off after 15/30/45/60 minutes. The timers can be
freely switched. Each time you press the timer button, the working time counts down again
from 15/30/45/60 minutes.
9. The product starts to count down, and the time display also counts down, displaying
15-14-13...
10. After the heating cycle is complete, the INTERIOR SURFACE of the Towel & Blanket Warmer
will remain dangerous to touch until the LED light turns off.
11. When the NTC is open, the error code is E0; when the NTC is short-circuited, it is E1; when
it is over temperature, it will display E3 (the temperature of the inner wall is higher than
140°C/284°F), in this case, it will automatically shut down and can no longer be turned on.
SETTING UP
USING THE TOWEL & BLANKET WARMER
8
