10
Protective helmets are part of your personal protection equipment and
help avoid head injuries or at least significantly reduce the consequences.
Please take some time to read the following instructions and information
on adjusting your helmet. It is in the interest of your safety and comfort.
Detailled information and illustrations can be found on the front pages.
1. General Information
According to the current technological standards, this cycling helmet
represents the best possible protection for your head against external
adverse effects. It can, however, never guarantee complete prevention
of injuries. Our cycling helmets fulfil the European standard VG1 01.40
2014-12. All helmets correspond with the European directive 89/686/EEC
and bear the CE marking. Within the scope of this standard, helmets are
tested for shock absorption, slipping, chin strap strength and coverage
zones.
2. Selecting the right helmet size
A helmet can only protect you if it fits properly. Measure your head circum
-
ference at the widest point and then select the right size.
The sizes of KED helmets are found on a label inside the helmet.
The helmet must feel safe and comfortable on your head. Try out different
helmets; you will notice initial differences straight away. Look in the mirror
- your helmet should suit you too.
3. Altering the size adjustment system
A good fit is a prerequisite for the best possible protection. This is why the
helmet is equipped with the QuickSafe adjustment system. The head ring
size can be suitably adjusted by turning the adjustment wheel. If you turn
the wheel in the „-“ direction the head ring tightens, and then releases
when turned in the „+“ direction (see figure 2).
4. Correct positioning
Always position the helmet horizontally on your head, so that your fore
-
head is protected but your vision is not impaired. Your helmet should not
be positioned towards the back of your head either (see figure 1).
5. Tight fit
You can check your helmet for a tight fit by shaking your head lightly with
the chin strap open. In doing so, the helmet should not slip. An optimal fit
is necessary so that the helmet fulfils its safety function 100%.
6. Strap adjustment
a)
If your helmet is equipped with a Quickstopp System (see fig. 4a or 4b),
GB
INSTRUCTION FOR USE
Summary of Contents for Quicksafe
Page 4: ...4 Höhenverstellung Kopfumfangverstellung 4 3 1 ...
Page 5: ...5 2 3 6 7 ...
Page 50: ...50 ...
