A2xx
Operation and handling
Operating instructions V1.01
35
© KEBA
The device has successfully been disconnected from the PC.
5.9
Bluetooth wireless interface
KeMes A2xx features an integrated Bluetooth Low Energy wireless interface
for the connection between device and press brake.
Switching on the Bluetooth wireless interface
To switch on the Bluetooth wireless interface, proceed as follows:
1) Navigate to the
Bluetooth
menu entry. The device serial number is dis-
played in the Bluetooth menu.
2) Enable the wireless connection by pressing the operating button once.
The Bluetooth icon appears on the display. The device is now ready for
a wireless connection to be set up.
How a wireless connection is set up and how the device is coupled to the re-
ceiver depend on the version and are described in the following chapters.
Sending measured values after a manual measurement
If the device is connected to a receiver, the device flashes once the mea-
surement of the measuring angle is complete. You can send the angle value
to the receiver by briefly pressing the operating button once.
When it is pressed twice briefly, the measured value is discarded and
---.--°
appears on the display. Briefly pressing the button again starts a
new measurement.
5.9.1
KeMes A200
This device variant supports complete integration into the press brake con-
trol system by means of a wireless interface. Make sure that the receiver
meets the requirements for a connection establishment.
Requirements for the connection establishment:
●
Bluetooth interface on the receiver with KeMes driver software
Setting up a wireless connection
To establish a wireless connection, the Bluetooth wireless interface must be
switched on. To establish the wireless connection, proceed as follows:
1) Starting the connection establishment by the receiver. A 4 - 6 digit con-
nection key (e.g. 273992) appears on the display for the first connection
establishment.
2) Enter the connection key at the receiver within 30 seconds.
The set up of the wireless connection is continued, and, in addition to the
Bluetooth icon, the connection quality is displayed (in 4 levels).
Summary of Contents for KeMes A2 Series
