Keba KeContact P30 x series, Configuration Manual

Page: 38 / 68

Commissioning
38/68
2 Commissioning
2.1 DIP switch settings
Changes to the DIP switch settings only become effective after a restart of the charging station! To do this,
press the
[service button] for 1 second or switch the power supply voltage off/on.
DIP switches…
The DIP switches are used for the addressing and con-
figuring the charging station and are located under the
connector panel cover.
[DSW1] …Configuration (DIP switch up)
[DSW2] …Addressing (DIP switch down)
DIP switch example setting…
For better explanation, the figure shows the position of
the DIP switches for the states ON and OFF.
Activating the communication module
CONNECTION TO HIGHER-RANKING SYSTEM (backend)
DSW2.1 to DSW2.4=OFF / DSW2.5=ON / DSW2.6=OFF
Activate the communication module.
Required for the OCPP connection of the Ke-
Contact P30 x-series to a backend.
D2.5 ON= yes
Phase assignment (load distribution)
PHASES (DSW1) / ONLY FOR LOAD MANAGEMENT MODE
Phase assignment (*) D1.4 D1.5