KC-P30 Charging Station
Description of the device
V1.03
13
© KEBA
The display may show different information depending on the operating sta-
tus (e.g. software version, IP address, authorization request). The main task,
however, is to display the relevant data of a charging session. During peri-
ods of inactivity, the display brightness is reduced and switched off after a
few minutes.
The preceding "MI" or "ME" indicates a notice relevant to calibration law. All
other indications on the display are informative.
The display lights up through the housing and is only visible when the power
supply is active. For further details on the display, see the "Operating In-
structions."
2.7
Brightness sensor
The brightness sensor is located on the front of the charging station on the
left below the LED bar. The information display can be triggered via the
brightness sensor.
1
... Brightness sensor
2.8
Pulse LED
The pulse LED is located on the front of the charging station on the right be-
low the LED bar. In test mode, the pulses of the pulse LED indicate a con-
clusion about the transmitted energy.