4-16
Operating Instructions CDF3000
4 Commissioning
4.4
Test run
Attention: Test run with motor installed
:
In this case it must be assured that the test will not cause any
damage to the system! Pay particular attention to the limita-
tions of the positioning range.
Please note that you yourself are responsible for safe opera-
tion. LTi DRiVES Antriebstechnik GmbH will not assume lia-
bility for any occurring damage.
Danger to life from uncontrolled rotation!
Before starting motors with feather keys in the shaft end
these must be reliably secured against being ejected, as far
as this is not already prevented by drive elements such as
belt pulleys, couplings or similar.
Pre-set solution for torque control
:
In this pre-set solution the drive must not be operated without
load torque, because otherwise the motor shaft would accel-
erate uncontrolled up to the adjusted speed limit.
Attention: Destruction of motor
:
The motors are intended for operation on the positioning con-
troller. Direct connection to the mains can destroy the motor.
The surface temperatures on the motors may increase to a
very high level. No temperature sensitive parts may touch or
be mounted to these areas, appropriate measures to prevent
contact must be applied wherever necessary.
A temperature sensor that may possibly be installed in the
winding, must be connected to the positioning controller, so
that overheating of the motor can be prevented by the tem-
perature monitoring system.
Before starting the motor the motor brake (if present) must be
checked for correct function.
The optionally installed holding brake is only designed for a
limited number of emergency brake operations. Use as work-
ing brake is strictly prohibited.
Summary of Contents for CDF3000
