6.2 Terminal blocks of the devices
The assignment of the numbering under "Terminal" for cross sections and tightening
„Cross-sections and tightening torques of the terminals“
The + contact of the temperature evaluation must be connected to terminal T1
to terminal block X1A! For more information
„Temperature detection T1, T2“
.
Housing E
Name
Function
Terminal
L1, L2, L3
3-phase mains connection
1
U, V, W
AIC mains connection
++, PB
Connection for braking resistor
++, – –
Connection for DC-bus connection
T1, T2
Connection for temperature sensor
2
PE,
Connection for protective earth
3
Figure 2:
Terminal blocks housing E
Housing G
Name
Function
Terminal
L1, L2, L3
3-phase mains connection
4
U, V, W
AIC mains connection
++, PB
Connection for braking resistor
++, – –
Connection for DC-bus connection
T1, T2
Connection for temperature sensor
2
PE,
Connection for protective earth
3
Figure 3:
Terminal blocks housing G
Housing H
Name
Function
Terminal
L1, L2, L3
3-phase mains connection
5
U, V, W
AIC mains connection
++, PB
Connection for braking resistor
++, – –
Connection for DC-bus connection
T1, T2
Connection for temperature sensor
6
PE,
Connection for protective earth
5
Figure 4:
Terminal blocks housing H
36
CONNECTION OF THE COMbIVERT F5-AIC
Summary of Contents for COMBIVERT F5 Series
Page 2: ......
