FIGURE 7.
BATTERY OF 2 FRYERS WITH SAFE & EASY
FILTER.
NOTE: ONLY 1 FRYER CAN BE
FILTERED AT A TIME
FIGURE 6.
Failure to do so may cause the drain lines to clog up.
NOTE:
If the pump shuts down, turn it off and let the motor cool.
Push the motor reset button located on the filter panel. Check
filtering procedure or clean tub and paper if needed.
6. Let swirling action rinse down fryer.
7. Fully drain fryer.
NOTE:
Pump should be run for at least 30 seconds after
crumbs are removed from fryer. This will help prevent blockage
in the drain lines.
8. Close drain valve by pushing in the large black knob and
locking it into place and completely refill fryer. Refer to
Figure 6.
NOTE:
The drain valve handle controls fryer’s Main Power
Switch.
If drain valve is not fully closed and locked, fryer
will not operate.
See Figure 6.
9. Turn pump switch to the “OFF” position. Close return valve
by pushing in the small black knob completely, after turning
OFF the pump switch (for units with more than one fryer or
central filter). See Figure 7.
D. CLEAN UP
WARNING
Filter drawer and pipes will remain hot following filtration.
Allow the unit to cool down before clean up. Failure to do
so may result in serious injury to the operator.
See 1-4 on page 1.
5. Remove crumb basket.
6. Push down on the 2 tension arms on the hold down ring,
rotate 90°, and remove.
7. Remove the used filter paper and discard.
8. Remove sump screen.
9. Throughly clean the entire filter tub and all components.
NOTE:
Tub and components are diswasher safe.
10. Prepare drawer for next use (see section A “Preparing the
Filter Drawer”).
NOTE:
Instructions for cleaning the fryer are in the Operating
Section of the Fryer Service Manual.
E. DISCARDING THE OIL
NOTE: The 6 foot hose provided with the filters should
be used to discard the oil ONLY. DO NOT use the filter
assembly to transport hot oil. DO NOT remove filter tub
containing hot oil!
1. Prepare the filter drawer (see section A).
NOTE:
Acidox is not needed when discarding the oil.
2. Prepare the oil (see section B).
3. Connect the hose to the right side of the filter assembly in
the front. See Figure 8.
– 3 –
Return valve (small
black knob) must
be pulled to open
when filtering and
pushed closed
when complete.
