© Copyright 2013 KE2 Therm Solutions, Inc., Washington, Missouri 63090
Quick Start Q.5.24 July 2013
Page 9
KE2
Smart
Gate
Installation and Setup
NAT/PAT
15
Once in the Firewall settings, select the NAT tab. There
will already be some information in this field, however, we will
select the ‘Add New’ option.
Once the NAT setup screen is present the user should identify
the appropriate areas of the configuration required for this
process. Refer to the figure for assistance.
To properly setup the NAT configure the following:
16
Make sure Enabled has a check mark
17
Chain = ‘dstnat’
18
Protocol = ‘6(tcp)’
19
DST to the port used by the external IP address, seleted by
the user, to access the KE2 Evap.
The Default port used by the KE2 Evap controller is TCP Port 80.
In single controller applications, the DST may be selected to 80
if not already used (i.e. camera system, etc.) Multiple control-
lers require the Network Address Translation process to be
completed for each controller attached to the KE2 SmartGate.
This will assign a unique Port to EACH controller allowing it to
be inidividually viewed.
For example:
use port 8081 for 1st controller
Use port 8082 for 2nd controller
User port 8083 for 3rd controller.
Accessing the controller remotely will be as simple as entering
http://xx.xx.xx.xx:8081 (xx = customer internet IP or Domain
Name)
15
17
18
19
16