KE2
Controlled
Environment
Quick Start Guide
Q.1.23 November 2014
Page 14
© Copyright 2014 KE2 Therm Solutions, Inc., Washington, Missouri 63090
Connecting sensor wires to controller
The sensors are designed to be attached to the controller using
screw terminals. Using a connector from the accessory kit, attach
each sensor to the appropriate screw terminal.
Connect all sensors to a screw terminal.
Once connected, the sensors should be plugged into the proper lo-
cation on the controller. The location can be determined from the la-
bel on the interior wall of the enclosure or from the Wiring Schematic.
Strain relief
The enclosure has been designed with a strain relief bar to pre-
vent the sensor wires from becoming unplugged from inadvertent
contact.
Before securing the sensor wires, create a service loop as shown in
Figure 32.
Using the cable ties from the accessory kit, securely fasten the sen-
sor wires to the strain relief bar.
Note: Unused connectors should be placed (installed) in their re-
spective location for future use.
32
32
Controller Mounting
Locate the 4 stainless steel screws in the accessories kit
Install the 4 screws
Place the controller on the mounting screws and tighten down the
screws.
33
33
Final Step
Leave the installation instructions onsite in a convenient location,
where it can be easily located, for future service.
34
