4
FEATURES
The Model 100 series are simple, accurate cost effective syringe pumps designed to hold glass
or plastic syringes, of any make, from 10 microliter to 60 milliliter for the KDS100; 10 ul to 15 ml
for the KDS120; and 10 ul to 10 ml for the KDS101.
The models
KDS100
and
KDS101
are infusion only pumps. The flow rates of the KDS101 and
six times slower than that of the KDS100 and the units of flow rate are suitably adjusted.
The
KDS120
is a push-pull infusion/simultaneous withdrawal pump.
Setup and pump operation for all the 100 series pumps are similar and extremely simple. A
menu, displayed on an alphanumeric LCD "prompts" the operator to make the necessary
selections using the keypad for choice of features and numerical entries.
The
internal diameter of the syringe
is used by the control program to calibrate the pump and
deliver the volume and flowrate selected. For simplicity the syringe diameter is also used to set
automatically the volume and flowrate units.
The syringe diameter can be
entered directly
or the syringe can be identified from a
table of
syringes
held in memory. When the syringe is selected from the table the diameter is entered
automatically.
Two dispense modes are available:
a)
dispense volume mode
in which the pump keeps track of the volume
dispensed and automatically stops the pump when a set target volume is
reached.
b)
run mode
where the pump runs at the set flowrate until manually
stopped.
In the event of a
power interruption
during operation, the pump can be programmed to either
resume operation or remain stopped when power is returned.
For convenience, all pump
settings are stored in non-volatile memory
to minimize the
number of setting changes required.
1)
KEYPAD FUNCTIONS
å
This key has two functions:
a. Moves the display to the left
b. Causes the numerical entry to
decrease.
To change the displayed number by a
single unit press and release the key quickly. If the key is pressed longer the
number changes with increasing speed.
ä
This key has two functions.
a. Moves the display to the right
b. Causes the numerical entry to
increase
. To change the displayed number by a
single unit press and release the key quickly. If the key is pressed longer the
number changes with increasing speed.
