V.A.C.
ATS Operations and Maintenance Manual
24
20.0
SWITCH PROTECTOR REPLACEMENT
20.1
Remove the Front Housing.
20.2
Disconnect the Battery.
20.3
Remove the Canister
Housing.
20.4
Unscrew the six screws
holding the complete Chassis
into the Rear Housing. Move
the Chassis to the left to allow
access to the switch.
20.5
Disconnect the Brown and
Blue wires from the
connector terminals of the IEC Inlet.
20.6
Disconnect the wires from the switch, and disconnect the L.E.D wires
from the Charger Board
20.7
Remove the IEC Inlet.
20.8
One at a time, depress the Switch Protector retaining tabs and gently
push the part out of the housing.
NOTE:
The Green L.E.D is glued into the Switch Protector. You will
need to cut the L.E.D wires in order to remove the Switch Protector. A
new L.E.D lead will need to be fitted to the new Switch Protector.
20.9
Fit the IEC lead and replacement Switch protector into the rear
housing.
20.10
Apply a small amount of M4273654 adhesive to the side of the green
L.E.D on the replacement L.E.D wire, and push fully into the L.E.D
hole on the top of the Switch Protector.
20.11
Re-assemble the unit by reversing the above procedure from 20.6.
20.8
RESTRICTED USE
Certain pages of this manual are designated
“Restricted Use Only.” Information contained on
those designated pages may be used solely to
facilitate the proper maintenance and repair of
KCI products identified herein. If these terms are
unacceptable, immediately remove those
designated pages and return them to KCI, Attn:
Legal Dept. Refer to qualified service personnel
who are authorized by KCI for proper
maintenance and repair
