USE OF DISPENSER
1. Filling the water reservoir for the 1st time use
•
Remove the reservoir door by simultaneously pulling both
the left and right sides towards you.
•
Add water to MAX WATER FILL and then replace the door.
•
Do not plug the unit into power until you have filled
water to the max fill line.
3. Making ice for the 1st time use
•
Add water to MAX WATER FILL following
instructions above
.
•
Plug the unit into power and the Power LED will
illuminate. Add Water LED will flash quickly with 5
beeps if the water reservoir is full.
•
Press the Make Ice button once to start making ice.
The Making Ice LED will
illuminate
to indicate the
unit is currently making ice.
4. Using the funnel to add water
•
Add water when the Add Water LED illuminates.
•
Insert the funnel into the water fill port.
•
Add water
until
the Add Water LED
flashes
quickly with 5 beeps and then goes off
.
•
Remove the funnel to close the fill port.
2. Flushing the unit for the 1st time use
•
Plug the unit into power and the Power LED will
illuminate. Add Water LED will flash quickly with 5
beeps if the water reservoir is full.
•
Press and hold the Clean button for 3 seconds to
start the cleaning cycle for flushing process. The
Cleaning LED will illuminate (it takes 30 minutes to
complete and the Cleaning LED goes off).
•
U
nplug the unit
when the flushing process is
complete.
•
Unhook the plugs/holders with drain tubes out of
the unit back and l
ower them to a bucket or sink.
•
Press and hold the release button to disconnect the
plugs/holders to release water.
•
Reconnect and hook them back to the unit.
ADD WATER
Do NOT add water until the Add Water LED
illuminates.
Overfilling the reservoir may lead to water
overflowing when ice melts completely.
CLEAN UNIT
Clean the unit once a month with a solution to
prevent scale buildup.
Add 12 teaspoons of citric acid or 1 cup of white
vinega.
Call or Text “Help” 800.433.9938 | [email protected] | www.kbgoodice.com
