Configuring the ESUL5P-D*
1.
Connect the DIN rail or wall-mount
brackets as required.
2.
Connect a 48Vdc power supply, (supplied
separately).
3.
If using only one power source, connect
pin 1 to pin 5 and pin 2 to pin 6 otherwise
the Power Fail LED will be lit.
4.
Link external devices to the switch with
appropriate cables.
5.
Connect the fault alarm contact
LED
Status
Description
P1
ON
Power is supplied to the unit
OFF
No power to the unit
P2
ON
Power is supplied to the unit
OFF
No power to the unit
P-Fail
ON
Power to input 1 or 2 has failed
OFF
Power is functioning to both or
none of the powered devices.
PoE 1-4
ON
The port is supplying power to
the powered device
OFF
There is no powered device
attached or the power to the
device has failed
Ethernet RJ45 Port Status LED
Each RJ45 Ethernet port has two indicators, a yellow lamp
and a green lamp. The yellow lamp indicates port speed,
and the green lamp indicates port link state.
10/100
(Yellow)
ON
Full duplex link
FLASH
Collisions are occurring
OFF
Half duplex link or no
connection
LINK/ACT
(Green)
ON
Effective network connection
has been established for the
port
FLASH
Data traffic is passing through
the port
OFF
No effective network connection
has been established for the
port
Need Help/Troubleshooting?
Visit our website
http://www.kbcnetworks.com
or
contact your nearest KBC office or dealer:
APAC:
Phone: +65 98463323
Email:
EMEA:
Phone:
+44(0)1622 618787
Email:
USA:
Phone:
+1 949-297-4930
Toll Free: +1 888-366-4276
Email:
Quick Start Guide
ESUL5P-D*
Industrial Ethernet Switch
ESUL5P-D* LED Status Indicators
QSG_ESUL5P-D-Rev1112
www.kbcnetworks.com
Copyright © KBC Networks Ltd. 2011
