EE2CL-3KT
Qty Description
4
EE2CL Extended Ethernet unit
1
48Vdc, 1.25A Power Supply Unit
1
1:4 BNC Splitter Adaptor
EE2CL-4KT
Qty Description
5
EE2CL Extended Ethernet unit
1
48Vdc, 1.25A Power Supply Unit
1
1:4 BNC Splitter Adaptor
The following are also available as individual units:
EE2CL-1:
Extended Ethernet unit
GS60A-48-P1J:
48Vdc, 1.25A PoE Power Supply Unit
EE2CL-RK:
19” high density rack system
EE-BNC4:
1:4 BNC Splitter Adaptor
EE-BNC2:
BNC T-Splitter
Equipment Required for Physical Deployment
You will need a 48Vdc, 1.25A power supply; this is supplied with each kit.
Physical Deployment
This equipment must be installed and operated in accordance with instructions found in the KBC Networks’
manual; failure to comply with these instructions will invalidate warranty.
Configuring the EE2CL
Basic configuration
1.
Remove all the packaging materials and labels.
2.
Choose a Master EE2CL unit; this can be any of the units purchased.
3.
Connect the 48Vdc power supply to the Master EE2CL unit.
4.
Check that the blue LEDs on both EE2CL units are lit.
Connecting the EE2CL to the camera
1.
Mount the EE2CL near to the IP camera.
2.
Connect an RJ45 cable between the camera and the RJ45 connector on the EE2CL unit.
3.
Connect the coaxial cable to the BNC connector on the EE2CL unit.
4.
If multiple camera units connect to a single Master unit then the 1:4 BNC Splitter Adaptor or BNC-T
adapter will be required.
Note:
Depending on power requirements and cable distances power for both the Master and Slave EE2CL units
and the IP cameras can be supplied from the PSU located at the Master EE2CL unit. For high power or long
distance systems, multiple PSU units will be required; see the full KBC Networks’ manual for further
information.
