eCopper™
QSG-EERF1-LS1-T-MN-B_Series-Rev2101
www.kbcnetworks.com
Copyright © KBC Networks 2021
Quick Start Guide
EERF1-LS1-T-MN-B
EoU Transmitter
–
1 UTP Connector and 1 RJ45
Introduction
The KBC EERF1-LS1-T-MN-B is a fully ruggedized Ethernet over UTP
transmitter. This transmitter provides connectivity for one 10/100Mbps IEEE
standard electrical copper port over UTP cable. Power is supplied from one of
the headend receivers, EERF16-GN3-R-RX-B, EERF8-GN3-R-RX-B, EERF4-DN1-R-
WN-B or EERF1-LN1-R-MN-B Ethernet over UTP units through the UTP cable by
Power over Wire (PoW) technology. The transmitter provides PoE+ support.
Varying data rates are supported depending on cable distance and quality. The
plug-and-play design ensures ease of installation with no electrical adjustment
needed. LED indicators are provided to show the operational status of the
unit.
The size of the transmitter is suited for fitting inside camera housings and
where space is minimal.
Features
•
802.3af/802.3at compliant
•
Power over Wire technology
•
UTP data rate >40Mbps (300m)
•
Based on cable quality, cable pairs used (1,2 or 4 pairs) and voltage
applied to cable (48~57VDC) from headend, PoE and PoE+ are supported
by PoW up to 400m
•
Powered by PoW from EERF16-GN3-R-RX-B, EERF8-GN3-R-RX-B, EERF4-
DN1-R-WN-B or EERF1-LN1-R-MN-B headend
•
Complete protection design including surge and lightning protection
•
Unique PoW transmission protection design together with a 1,4,8 or 16
channel receiver headend
Downloads
Full specifications, features and additional information can be found on the
KBC website:
