IODF INPUT/OUTPUT MULTI-FUNCTION EXPANSION MODULE KIT (PART NO. 9646)
INSTALLATION AND OPERATION INSTRUCTIONS
KB
Electronics,
Inc.
12095 NW 39th Street, Coral Springs, FL 33065-2516
●
(954) 346-4900
●
FAX (954) 346-3377
Outside Florida Call Toll Free (800) 221-6570
●
www.kbelectronics.com
Page 4 of 4
(A40193) – Rev. A00 – 5/7/2013
Other Programmable Functions of the Multi-Function Output Relay (Function 5.01)
Code Description
0000:
Run
0001:
Fault
0002:
Target Frequency (Function 5.03 ± Function 5.04)
0003:
Frequency Threshold Level (>Function 5.03 – Function 5.04)
0004:
Frequency Threshold Level (<Function 5.03 + Function 5.04)
0005:
I
2
t or I•t Fault
0006:
Load Loss (See Function 5.05)
0007:
External Fault
3.3 ANALOG INPUT
Connect the 0-2.5 thru 0-25 Volt DC signal input to Terminal "18" and the common to Terminal "19". Connect the Start (Jumper) to Terminal
"9" (on the drive's TB1), which is factory set for N.O. Start ("0010"), and to either common Terminal "4" or "11"(on the drive's TB1).
3.4 SCALE TRIMPOT
If the input Signal is higher than 5 Volts DC, use the SCALE Trimpot to attenuate it. Apply the maximum signal input and set the drive for full
speed output and observe the display. Rotate the SCALE Trimpot counter clockwise until the drive output frequency begins to drop. Then,
rotate the SCALE Trimpot clockwise until the display returns to the maximum output frequency.
Set the signal Slope and Type and adjust the Gain, Offset, and Response Time as desired. See Section 8.4.2.1, on page 30 of the manual.
4 DIAGNOSTIC LEDs
The two LEDs provide indication of operational status of the IODF. See Figure 1, on page 1, for the location of the PWR (Power On) and ST
(Status) LEDs.
PWR (Power On) LED:
When power is applied to the drive, the PWR LED will illuminate green.
ST (Status) LED:
During normal operation, the ST LED is not illuminated. If the IODF experiences a communication error, the ST LED will
flash red. If the ST LED flashes, disconnect power to the drive and recheck that the IODF is properly installed. If, after checking the installation
of the IODF, the ST LED flashes again, contact our Sales Department.
5 INSTALLING THE NEW COVER
After installing and wiring the IODF, it is necessary to install the new cover (supplied). For Case A drives, use the small cover and for Case B
drives, use the large cover. Insert the cover's tab into the slot on the drive and then gently press down on the cover until it snaps into place
and is secured onto the drive.
END OF INSTALLATION INSTRUCTIONS