•
Insert funnel into the
water port
• Add
distilled, bottled OR filtered water
until the
Water Level
LED button
illuminates
in green. You
will hear
5 beeps.
• Re
move
the
funnel
to close
port
2. Flushing the unit for the
1st
time
• Plug the unit into power.
• Press and hold Clean button for 3 seconds to start
the Cleaning mode
• Unplug the unit when the flushing process is complete
(it takes 30 minutes and the Cleaning LED goes off).
• Pull the drain tubes with plugs/holders out of
the unit back and remove the plugs/holders to
release water.
• Replace the plugs/holders and put the tubes with
plugs/holders back to the unit.
3.
Making ice for the
1st
time
.
IMPORTANT
•
We recommend using
distilled, bottled OR
filtered water
, as this will improve the
performance of the machine. Tap water with a
hardness of <100 PPM is also acceptable. The
machine will
NOT
produce ice if tap water with a
hardness > 100 PPM is used
•
Unplug the machine
•
Remove the reservoir door and fill the machine by
sight to the max fill line, located on the back of the
water reservoir.
•
Replace the cover and p
lug the unit into power.
• Press Make Nuggets button once and wait for the
Making Ice LED to flash slowly
Pug/Holders
Drain Tubes
Water
Port for
Funnel
Reservoir
Cover
©KB Ice & H²0, LLC
www.kbgoodice.com
Note:
Funnel is Packed Inside the Reservoir
FIRST TIME USE
D
ispense several cups of ice and discard
them.
1. Filling the water reservoir for the first time use
• Remove the reservoir cover by simultaneously
pulling from the left and right side towards you
• Add water to MAX WATER FILL and then
replace cover.
USE OF DISPENSER
Water
Port
L
R
Reservoir
Cover
MAX Water Fill
Magnets
MIN Water Fill
4
.
Using the funnel