background image

shuts off, empty the residue in the medicine cup and clean with a soft tissue. Add fresh inhalant after 
refilling water container.

• 

PLUG IN VAPORIZER. IMPORTANT

: Vapourizer will NOT START unless vapourizer has been 

disconnected for at least one minute. Nightlight will illuminate when electricity is connected. This 
will indicate that the heating unit is functioning. 

  Vapourizer will produce a gentle flow of steam within a few minutes. Do not lift or move the 

vapourizer while in use.

• 

OPERATION

: Vapourizer will shut off automatically when the water reaches a minimum level (about 

20 mm from bottom of container). 

• 

VENTILATE ROOM REGULARLY

: When vapourizer is used in closed or small rooms, check periodically 

for proper ventilation, as excessive humidity can cause condensation on walls.

• 

AFTER EACH USE

: Empty any unused water from the container. Rinse container thoroughly, drain 

and wipe with a dry, clean cloth. To maintain proper operation of your vapourizer, be sure to follow 
CARE AND CLEANING instructions.

Care and Cleaning

IMPORTANT SAFETY CAUTIONS

: Always disconnect the plug from the electrical outlet before cleaning. 

Remove heating unit, letting all water drain back into the container. Do not attempt to disassemble the 
heating unit. Doing so could damage the vapourizer or cause personal injury, and will void the warranty.

Daily Maintenance

Empty any unused water from container. Rinse container thoroughly, drain and wipe with a dry, clean cloth.

Weekly Maintenance

Empty any unused water from container. Rinse 
container thoroughly, drain and wipe with a 
dry, clean cloth. 

Soak heating unit in 8 cm (3 inches) of white 
vinegar for 10 minutes (Fig. 4). Use a butter 
knife to gently remove any minerals from the 
metal heater surface (Fig. 5). Access to the 
heater surface can be obtained by lifting the 
hinged cover on bottom of unit.

CLEAN THE HEATER SURFACE AFTER EACH 
150 HOURS OF OPERATION.

Open hinged cover on bottom of heating unit 
for access to the heater surface for cleaning 
only. Use a butter knife to gently remove any 
minerals from the metal heater surface. More 
frequent cleaning may be required in hard-
water areas. 

For proper operation, the cover must be shut 
and in the correct position.

Instructions

• 

CORD CAUTION

: Unravel cord before use. Failure to do so could cause overheating and possible fire hazard.

• 

DISCONNECT CORD

: Always disconnects cord at wall plug before 

removing the heating unit, filling, cleaning, or when not in use. 
IMPORTANT: The heating unit will not operate unless the plug has 
been disconnected from electrical outlet for about 1-2 minutes 
prior to reconnecting.  

• 

REMOVE HEATING UNIT

: Lift the rear of heating unit cap and 

slowly rotate in a counter-clockwise direction until the slanted 
portions of the two locking tabs is cleared. Then lift the heating 
unit directly upwards until the locking tabs are clear of the water reservoir. (Fig. 1)

• 

FILL THE CONTAINE

R: Fill container with tap water to the MAX water 

level marked on the water reservoir.

DO NOT OVERFILL

. (Fig. 2)

• 

REPLACE HEATING UNIT

: Align the two locking tabs on the side 

of the heating unit with the two slots in the water reservoir. The 
heating unit will only engage the water reservoir in the proper 
orientation. Seat the heating unit into the locking tabs of the water 
reservoir, then rotate the head clockwise to hold unit in place. 

• 

PLACE VAPORIZER IN STABLE POSITION

: Vapourizer should 

always be placed on a firm, flat surface at least 1.2 meters 
(4 feet)  from bedside. For safest operation, vapourizer should be placed on floor, where it cannot fall 
or be pulled down. Be sure the power cord is out of the way to prevent vapourizer from being upset. 
Protect floor, rug or furniture by placing the vapourizer on a non-metallic heat-resistant surface.

CAUTION

: Do not direct steam flow directly at recipient, walls or furniture. Recipient will still obtain 

desired level of humidity. 

KEEP OUT OF THE REACH OF CHILDREN; STEAM CAN CAUSE BURNS

. This appliance is not intended 

for use by young children or infirm persons without supervision. Young children should be supervised to 
ensure that they do  not play with the appliance.

• 

INHALANT STEAM ACTIVATED

KAZ INHALANT or VICKS VAPOSTEAM can be filled is the medicine cup. Those products are not 
delivered with the vapourizer but are available on some websites. You can use steam inhalants or 
medicine oils brands available in drugstores and 
pharmacies. For best results, fill the medicine 
cup on the cap (located in the front of the of the 
steam outlet vents) with the steam inhalant or 
medicine oil product. DO NOT put this oil or steam 
inhalant in the water tank, it must be put in the 
medicine cup and not inside the tank. Any brand 
or medicine into the water tank will damage the 
unit and void the guarantee. (Fig. 3)

  These inhalants are designed for use on one 

vapourizer cycle (12-14 hours). After vapourizer 

IMPORTANT SAFETY INSTRUCTIONS

Read through all the instructions before starting to use the appliance. Keep this 

manual in a safe place for future reference.
These instructions shall also be available on our website. 

Please visit www.hot-europe.com.

•  This appliance must only be operated as instructed in this user manual.
•  This appliance can be used by children aged from 8 years and above and persons 

with reduced physical, sensory or mental capabilities or lack of experience and 

knowledge if they have been given supervision or instruction concerning use of 

the appliance in a safe way and understand the hazards involved. Children shall 

not play with the appliance. Cleaning and user maintenance shall not be made by 

children without supervision.

•  This appliance is only designed for indoor use. Do not place it in direct sunlight, 

high-temperature areas or near computers or sensitive electronic equipment. 

Keep the appliance away from heat sources such as stoves, heaters, etc.

•  Place the appliance on a firm, even, non-metallic and waterproof surface. This 

humidifier may not work properly on an uneven surface. 

•  Kaz will not accept responsibility for property damage caused by water spillage.
•  Only connect the appliance to a single-phase AC supply to the voltage shown on 

the rating plate.

•  Do not use an extension cord. Doing so could cause overheating, fire hazard or 

electric shock.

•  Do not cover the mist outlet or put anything on it while the humidifier is running.
•  If surplus humidity forms condensation on walls and windows in closed or small 

rooms, turn the power switch to the lower setting and open the door to the room.

•  Do not touch the hot steam. Steam can cause burns.
•  If the supply cord is damaged, it must be replaced by the manufacturer, its 

service agent or similarly qualified persons in order to avoid a hazard.

•  Do not use this appliance if it is damaged or shows any signs of possible damage 

or if it is not functioning properly. Disconnect the power plug from the power 

socket.

•  This humidifier requires regular cleaning. Refer to the cleaning instructions. 
•  Turn the humidifier OFF if you notice moisture on the inside of your windows. 

For proper humidity reading use a hygrometer, which is available in many 

hardware and department stores.

•  Never use the device with wet hands.
•  Never pull the cord, always pull the plug.
•  Always ensure that device is on a level surface.
•  Always ensure that the cable is fully unravelled and has no knots in it.

Fig.3

Fig.2

Fig.4

Fig.5

Fig.1

Reviews: