29
Step 1: Remove the front grille.
1.
Push both of the tabs towards the middle
simultaneously to unlock the hook on the
grille.
2.
Hold the grille at a 45° angle, lift it up
slightly and detach it from the main body.
Step 3: Install the panel
Align the front panel to the main body,
considering the position of the piping and drain
sides. Hang the four latches of the decorative
panel to the hooks of the indoor unit. Tighten
the panel hook screws evenly at the four
corners. (See Fig 10.3)
Adjust the panel by turning it to the arrowed
direction shown in Fig 10.3 so that the ceiling
opening is completely covered.
Latch
Piping side
Drain side
Fig. 10.1
Step 2: Remove the installation covers at the
four corners by sliding them outwards.
Screwdriver
Fig. 10.3
1.
Connect the two louver motor connectors
to the corresponding wires in the control
box.
Control box
Fig. 10.2
Connect the
louver motor
Connect the
louver motor
Fig. 10.4
Panel Installation
10
NOTE:
Tighten the screws until the thickness of
the sponge between the main body and the
panel reduces to 4-6mm (0.2-
0.3”).
The edge
of the panel should be in contact with the
ceiling well.
Pan
el
In
st
all
at
ion
CAUTION
DO NOT
place the panel face down on the floor,
against a wall, or on uneven surfaces.
Summary of Contents for KCIS-52 DR11
Page 40: ......
