Restore initialization
If the user accidentally sets the display language of the wire controller to a language that
the user does not know, the following three steps can be used to restore the wire controller
to the factory setting and reset the display language:
1) Power off the wireline controller and power it on again. Press and hold + + to
enter the following page within 60 seconds.
2) Press the buttons from left to right, from top to bottom, click -> ▲ -> ->... Turn on 1, 2,
3, 4, 5, 6, 7, 8 and 9, wait for 100% initialization, and enter the FCT page. After entering the
FCT page, the version number is displayed. All set parameters of the equipment are reset
to the default parameters, and saved. The timing settings and fault records are cleared. The
equipment returns to the factory state. (exit FCT after power on again).
3) Power off the wireline controller and power it on again. The display language will be
reset. Press " ▲ " " ▼ " " ◄ " " ► " to select the language of the remote controller. After
the language setting is completed, click "
", select "YES", and then click "
" to enter
the SETTING ADDRESS interface. After setting SETTING ADDRESS, click "
" to enter
GENERAL SETTING. Then after setting GENERAL SETTING, click "
".
Summary of Contents for KCCHT-06 MODBUS
Page 55: ...WP MD20U 034B EN 16127100001177...
Page 56: ......
