Closing curtains during heating also helps
keep the heat in
Doors and windows should be kept closed
Page 9
• The air conditioner turns to FAN ONLY mode
from COOL or HEAT mode
(for cooling and heating
models only)
When the indoor temperature reaches the set
temperature setting, the compressor will stop
automatically, and the air conditioner turns to FAN only
mode. The compressor will start again when the indoor
temperature rises on COOL mode or falls on HEAT
mode to the set point.
Droplets of water may form on the surface of the indoor
unit when cooling occurs in relatively high humidity
(defined as high than 80%). Adjust the horizontal
louver to the maximum air outlet position and select
HIGH fan speed.
• Heating mode
(for cooling and heating models only)
The air conditioner draws in heat from the outdoor unit
and releases it via the indoor unit during heating. When
the outdoor temperature falls, heat drawn in by the air
conditioner decreases accordingly. At the same time,
heat loading of the air conditioner increases due to larger
difference between indoor and outdoor temperature.
If a comfortable temperature cannot be achieved with
the air conditioner alone, it is recommended that you
use a supplementary heating device.
Lightning or a car wireless telephone operating neraby
may cause the unit to malfunction. Disconnect the unit
from its power source and then re-connect the unit
with the power source again. Push the ON/OFF button
on the remote controller to restart operations.
Energy Saving Tips
• DO NOT
set the unit to excessive temperature levels.
• While cooling, close the curtains to avoid direct sunlight.
• Doors and windows should be kept closed to keep cool or warm air in the room.
• DO NOT
place objects near the air inlet and outlet of the unit. This will reduce the efficiency of the unit.
• Set a timer and use the built-in SLEEP/ECONOMY mode if applicable.
• If you don't plan to use the unit for a long time, remove the batteries from the remote control.
• Clean the air filter every two weeks. A dirty filter can reduce cooling or heating efficiency.
• Adjust louvers properly and avoid direct airflow.
