15. Install the front disc brake lower pump back
on the shock absorber, use tool
①⑥
to tighten
the fixing screws (torque requirement is 10-
12N.m) (after the front wheel is assembled,
remove the vehicle to the ground).
17. Install the end of the pedal to the rear brake
as above, then install the washer and cotter pin
(the cotter pin is bent at an angle greater than
180°)
16. Install H to the frame as shown above, use tool
⑩
to install the spring to the pedal.
18. Install L to the vehicle as above, use tool
⑬
to
tighten the fixing screw (the angle of the shift lever
is 10° parallel to the ground)
19. Install I to the vehicle as above (the cotter
pin is bent at an angle greater than 180°)
20. Use tool
②⑬⑮
to remove the fixing screws of
the seat cushion and plastic parts.
