Chapter 7: Defining Study Setups
Kaye ValProbe RT User Manual
69
7.8. Specifying Qualification Study Conditions
Figure 77: Qualification Parameters
Specify the conditions that control your qualification study on the
Qualification Parameters
screen. From this screen, you specify:
Qualification start/stop conditions - used to start and stop the qualification cycle manually or
automatically.
Data storage options - the rates at which data is written to the memory of the Logger during a
qualification run. There are three options, Sampling Rate, RF Transmission Rate, and RF
Threshold.
When you have finished, press
Review
to check your entries and save the setup.
Summary of Contents for ValProbe RT
