Camera Link Range Extender over Fiber User Manual
17
5.2
Completing the
KY-EXT-CL
system installation
In order to properly complete the
KY-EXT-CL
system installation, the following steps must be
taken:
1.
Make sure the fiber cable is connected properly, as described in previous section. Please
refer to Figure 11 as reference:
Figure 11 : Fiber cable connectivity
2.
Connect the Camera link cables, as shown in Figure 11.
3.
Connect the Power Adaptor to the
KY-CL2F-D
and
KY-CL2F-H
power supply
connector. The
KY-EXT-CL (Host and Device)
requires 12V power supply for proper
function for camera. Please, refer section 7.2 of this document for exact Power Supply
requirements.
4.
Connect the power supply to the camera (Regardless of the cameras PoCL support).
5.
Turn the camera and the computer on.
6.
Configure the Host Unit using terminal commands described in section 6.2.3.
The following parameters should be configured:
a.
UART baud rate (uartbaud)
b.
Camera link operation mode (format command)
7.
Issue save command to save active configuration.
Installation and Configuration
Device Unit
Host Unit
Base
Full
Full
Base
