Page no. 11 | Error! Not a valid bookmark self-
reference.
6
Error! Not a valid bookmark self-reference.
6.1
Installation procedure
The
KY-EXT-CL
system, on the host side (KY-CL2F-H
Host Unit
) is connected to Camera Link Frame Grabber.
On the device side (KY-CL2F-D
Device Unit
) the system is connected to the camera, as described in Figure 3.
CL cables
CL cables
Camera Link
Frame Grabber
Power
supply
Camera Link
Fiber cable
(up to 80 km)
Camera Link
Range
Extender
Host unit
Camera Link
Range
Extender
Device unit
Power
supply
Figure 3 : KY-EXT-CL connection diagram
6.1.1
Camera Link Frame Grabber installation
Before KY-EXT-CL system installation please make sure your Camera Link Frame Grabber and software
application are properly installed on the computer, according to the installation instructions document,
provided by the vendor of your Camera Link Frame Grabber.
6.1.2
Installing and Removing SFP+ Modules
The purpose of this section is to demonstrate how to install SFP+ transceiver module, attach an optical
network cable and remove an SFP+ transceiver module. It is necessary to understand the correct way of
installing and removing an SFP+ transceiver, as correct operation can protect the module from being
damaged and ensure its stable performance. Before removing or installing an SFP+ module, please follow the
precautions and installation instructions.
