Chapter 2
Installing the Music Teaching Lab Expansion Kit(s)
Installing the Music Teaching Lab Expansion Kit is straightforward and
can be done by anyone with basic technical knowledge.
Step 1
If the Music Teaching Lab System is installed, switch unit off and remove
all cables connected to the Music Teaching Lab Expansion Kit. If the
multiconductor cables plugged into the student boxes are not labeled, it is
recommended that you label them before removing them from the Music
Teaching Lab System. This will make replacing the cables easier.
Step 2
Remove the 7 black screws from the top panel, 7 black screws from the
back panel and 4 screws from the RCA connectors on the back panel as
shown in the following diagram.
Remove these screws
Remote Ethernet
On/Off
Power
9VAC
Teacher
Right
Mon Out
Rec Out
CD In
Aux In
6
5
4
1
2
3
8
7
Left
Music Teaching Lab Hub Rear Panel
Step 3
Lift and remove the top/rear panel from the rest of the Lab Hub.
