Kawai Concert Artist Classic series CS3, Owner'S Manual

Page: 38 / 52

38
Ap
p
e
nd
ix
Assembly Instructions
Please read these assembly instructions thoroughly before attempting to assemble the CS3 digital piano.
Please ensure that two or more people work on assembling the CS3 digital piano, especially when lifting
the main body of the instrument onto the stand in step 3.
„
Included parts
Before attempting to assemble the CS3 digital piano, ensure that all parts below are included.
A Phillips-head screwdriver (not included) will also be required in order to assemble the instrument.
b
Side panel
(left, right)
f
Power cable
c
Music rack
e
Pedal board
Pedal support bolt
d
Back board
h
Screw (with flat washer and spring
washer) x 4
j
Tapping screw (long, black) x 4
k
Tapping screw (mid, black) x 4
l
Tapping screw (short, silver) x 4
i
Screw (short, black) x 2
g
Cover strips
Headphone
hook x 1
Mounting
screw x 2
m
Headphone hook set x 1
a
Main body
1. Assembling the side panels
b
, pedal board, and pedal support bolt
e
Unfasten and extend the pedal connection cable attached to
the bottom of the pedal board
e
.
Insert the pedal support bolt approximately 1 cm into the
pedal board, using the hole shown in the diagram.
Attach the pedal board
e
to the left and right side panels
b
using the alignment screws located on either end of the pedal
board. Ensure that the correct side panel is used for the left
and right side.
Ensure that the pedal board and side panels make close
contact, and that there are no large gaps between the
assembled parts.
Insert the four short silver tapping screws
l
into the holes as
shown, and securely fasten the pedal board to the and left and
right side panels.
2. Attaching the back board
d
Allow the assembled pedal board and side panels to stand
upright (vertically) on the floor.
Temporarily fix the back board
d
to the left and right side
panels using the four long black tapping screws
j
, leaving a
tightening allowance of approximately 1-2 mm.
Then attach the bottom of the back board to the pedal board
using the four mid-length black tapping screws
k
.
k
b
Alignment
screw
Pedal cable
Pedal support bolt hole
Alignment
screw
k
e
b
Alignment
screw
Pedal cable
Pedal support bolt hole
j
j
k
k
k
k
j
j
d
j
j
k
k
k
k
j
j
d