Instructions for use EXTRAmatic 9040
5 Operation | 5.3 Utility programs
Extraction level
▶ Using the up or down button, select the required extraction level (24, 36, 48 or 72
units) and choose ENTER to store the extraction level.
Factory setting: 24 units
Optimum operating mode
▶ Using the up or down button, select Optimum operating mode and choose EN‐
TER.
▶ Using the up or down button, select "yes" or "no".
Choosing Optimum operating mode "yes" means that this workstation shall always re‐
ceive the extraction level configured. If insufficient extraction power is available, other
workstations will be locked.
Choosing Optimum operating mode "no" means that this workstation shall receive the
extraction level configured if this amount of power is available. The other workstations
will not be locked and the extraction level may drop below that configured.
Factory setting: Optimum: No.
Identification
▶ Using the up or down button, select Identification mode and choose ENTER.
▶ Using the up or down button, select Current, Control input or Continuous and
choose ENTER.
"Current" identification
This workstation is started up by connecting to the mains.
"Control input" identification
This workstation is started up by a control signal (e.g. foot switch or K-Control).
"Continuous" identification
This workstation is in continuous operation mode.
Factory setting: Current identification
Adapt unit
▶ Using the up or down button, select "Adjust unit" and choose ENTER.
▶ Using the up or down button, select "HF" or "no" and choose ENTER.
If you are running an HF unit at this workstation, select HF; otherwise, select "no".
Factory setting: Adjust unit: No
33 / 56
Summary of Contents for EXTRAmatic 9040
Page 1: ...Instructions for use EXTRAmatic 9040 Always be on the safe side...
Page 55: ......
Page 56: ...1 003 7096 Fk 20140715 3 en...
