Instructions for use ERGOcom 3
5 Operation
|
5.3 Operating ERGOcom 3 comfort/excellence
or
▶ Hold down the footswitch for < 2 seconds.
The current video signal generates a still on screen 1.
▶ Press the Freeze button again to return to live image display and activate the
next image (1-4) as a live image.
or
▶ Press the footswitch again to return to live image display and activate the next
image (1-4) as a live image.
5.3.9 Save still
Requirement
● The ERGOcom 3 is connected to a PC by USB cable.
● The grabber card is connected to VIDEO OUT 1 or VIDEO OUT 2.
● The KaVo Device Interface System software is installed on the PC.
▶ Hold down the Freeze button for > 2 seconds.
The save is shown on screen 1.
or
▶ Hold down the footswitch for > 2 seconds.
The save is shown on screen 1.
Note
The active image will always be saved to the USB drive if the 'USB pict. store' has
been set to 'on'. The image number of the active image is shown in white.
The signal emitted for the grabber card corresponds to the view shown on screen
1 (full-screen or quad mode). In contrast, the USB drive always saves the full-
screen image.
See also: 5.1.5 Configuration menu items, Page 23
37/54
